But you still need to activate your account.
Dear Jim: We are building a smaller empty nester home. We would like a two-story home, but my knees are bad. Is installing an elevator a feasible option, and does one use excessive electricity?
Dear Pat: Installing an elevator in a home is certainly a feasible option and is becoming much more popular as the general population ages.
These small elevators, about the size of a coat closet, are specifically designed for residential applications, yet they include all the commercial safety features.
Many people prefer a two-story home for its appearance and ability to isolate the bedrooms from the higher activity-level first-floor rooms.
Two-story homes also are often less expensive to build than a ranch home of the same square footage and provide more design flexibility on smaller lots. As empty nesters with bad knees, you likely don’t want a big lawn to maintain.
The cost of installing an elevator starts at about $12,000.
If this allows you to build a two-story home instead of a ranch, you will reduce the building costs with a smaller foundation and roof. You also will have a greater lot selection because sloping lots, where the garage might have to built under the house, will now be feasible with an elevator.
The electricity cost to operate an elevator is not great. It requires 220-volt service similar to your electric range and clothes dryer. An elevator moves at about 40 feet per minute, so it takes less than 30 seconds to move from floor to floor. With the smaller roof on a two-story, your savings on heating and cooling will be much greater than the electricity one uses.
Your builder will install the shaft for the elevator. It will have a swinging door and look similar to another closet. Once the shaft is built, an elevator technician will handle installing it. The safety door on the elevator typically is a metal scissors or folding panel type.
Most residential elevators offer the option of doors on several sides. This might cost a little more, but it provides more flexibility on the placement of the elevator. You will be able to access it from different sides on different floors of your house.
You have two basic mechanical design options: cable and hydraulic. Both are equally safe and use about the same amount of electricity. A cable design uses a motor and a steel cable to lift and lower the elevator. It is less expensive than a hydraulic one, but it sometimes requires more space.
A hydraulic model typically runs a little smoother than a cable one. The small hydraulic pump can be located away from the elevator so it may be better where there are space constraints.
The following companies offer residential elevators:
Cemcolift 1-800-962-3626 www.cemcolift.com
Concord 1-800-661-5112, www.concordelevator.com
Residential Elevators 1-800-832-2004, www.residentialelevators.com;
Thyssenkrupp Access 1-800-829-9760, www.dreamelevator.com;
Waupaca Elevator 1-800-238-8739, www.waupacaelevator.com.
Send inquiries to JAMES DULLEY, 6906 Royalgreen Drive, Cincinnati, OH 45244, or visit www.dulley.com
Comments
comments for this post are closed